industrial-chemistry-2017-scientifictracks-abstracts

5 / 25

Page 33
Notes:
conferenceseries.com
Volume 3, Issue 2 (Suppl) Ind Chem
ISSN: 2469-9764, ICO an open access journa Industrial Chemistry 2017
May 22-23, 2017
May 22-23, 2017 Las Vegas, USA
2nd World Conference on
Industrial Chemistry and Water Treatment
Hybrid water treatment process of alumina ceramic ultrafiltration and PP beads with air back-
flushing: Effect of pH and polypropylene beads
Jin Yong Park and Soojung Lee
Hallym University, South Korea
For advanced water treatment, effects of pH and pure PP beads packing concentration on membrane fouling and treatment
efficiency were observed in a hybrid process of alumina ceramic MF and pure PP beads. The tubular UF membrane
(NCMT-5231) with pore size 0.05 μm was manufactured by α-alumina in nanopore materials. The diameter of PP beads was
4-6 mm, and the synthetic feed was prepared with humic acid and kaolin. The synthetic feed was allowed to flow inside the
MF membrane and the permeated contacted the PP beads fluidized in the gap of the membrane and the acryl module case
with outside UV irradiation. Periodic air back-flushing was performed to control membrane fouling during 10 sec (BT, back-
flushing time) per 10 min (FT, filtration time). These results were compared with the previous studies. The membrane fouling
resistance (Rf) was minimum at 50 g/L of PP beads concentration. Finally the maximum total permeate volume (VT) was
acquired at 50 g/L of PP beads. It means that the membrane fouling could be controlled by PP beads at 50 g/L. The treatment
efficiency of turbidity decreased slightly from 99.4-99.0% as PP beads concentration decrease; however, that of dissolved
organic materials (DOM) decreased dramatically from 87.8-73.9% as decreasing PP beads concentration. It means that more
PP beads could adsorb or photo-oxidize DOM more effectively. The Rf increased as increasing pH of feed as compared and
the maximum VT was acquired at pH 5.1. It means that the membrane fouling could be inhibited at low acid condition. The
treatment efficiency of turbidity was almost constant independent of pH; however, that of DOM was the maximum at pH 6.5.
It means that the DOM could be removed more excellently at the low alkali condition.
Biography
Jin Yong Park has his expertise in membrane separation technology for water or wastewater treatment at Department of Environmental Science and Biotechnology,
Hallym University, Korea. Recently, he has researched the hybrid water treatment process of ceramic membrane and polymer beads coated with photocatalyst.
He was involved in the projects of artificial kidney and reverse osmosis for drinking water as Research Scientist in Membrane Laboratory, KIST, Korea and
developed the group contribution method to predict the permeability of gas separation polymer membranes as a Postdoctoral Fellow at Centre for Polymer
Research, University of Texas at Austin, USA. He has worked as a Visiting Professor at the Department of Civil and Environmental Engineering, UCLA, USA. He
has performed more than 40 projects and has published 70 articles related to membrane technology including 20 articles in SCI journals. Also, he has worked as
General Affairs Director, Editor-In-Chief and Executive Director in the Membrane Society of Korea
Jin Yong Park et al., Ind Chem 2017, 3:2 (Suppl)