Page 135
Notes:
conferenceseries
.com
Volume 6, Issue 4 (Suppl)
J Material Sci Eng, an open access journal
ISSN: 2169-0022
Materials Congress 2017
June 12-14, 2017
June 12-14, 2017 Rome, Italy
Materials Science and Engineering
9
th
World Congress on
Manufacturing of gasket sheet using paper manufacturing process without organic solvent
Yoonjong Yoo
1
, Hyejeong Lee
2
, Minchul Ha
2
, Seongki Kim
2
and
Sanghoon Lee
2
1
Korea Institute of Energy Research, Republic of Korea
2
JEIL E&S Co. Ltd., Republic of Korea
T
his paper is about ceramic gasket manufacturing technology that can be used in extreme temperatures.This gasket is manufactured
using ceramic fiber and talc as main raw materials, and inorganic content is about more than 95 percent. Therefore, gasket has
thermal stability, chemical and corrosion resistance and superior properties. So the chemical plant, high pressure thermal processing,
streamlines and can be used. In this study, paper manufacturing method applied for preparation of the ceramic gasket sheet and its
new economic process will be discussed. Inorganic fiber, talc and binders evenly distributed in the water for manufacture the gasket.
Then dehydration on the wire mesh by supplying the slurry, and compression, through drying process completed the gasket for
extreme temperature. The characteristics of manufactured product during the experiment like tare density was 1.88g/cm
3
, tensile
strength was 0.15 kg/mm
2
, compressibility 39%, recovery 17% and ignition loss 6.55% at 1,000ºC. And there was no pressure drop
when subjected to 150 LB (two inch) 10 kgf/cm
2
nitrogen for 10 minutes. All the additives are being evenly distributed to the surface
of the gasket, and each other's bonds have been completed successfully, and the applicability by paper manufacturing process.
Solvent free gasket manufacturing process
1) All gasket materials such as water-based latex, mineral fiber and fillers are easily in water and evenly distributed.
2) Was dehydration a lot of influence on the size of the cohesion within the slurry in forming process.
3) An example a continuous process for a product is as follows: Mixture of raw materials
→
forming and dehydration
→
third stage
compression
→
two stage drying
→
third stage calendering
→
rolling
4) New process is no odor is a clean work environment.
Acknowledgment
This subject is supported by Korea of Environmental Industry& Technology Institute(KEITI), Korea Ministry of Environment (MOE)
as “Advancement ofEnvironmental IndustryTechnology DevelopmentProgram”(PN :1485013985)
Biography
Yoonjong Yoo's Major Research Fieldare Honeycomb adsorbents for VOC, CO
2
, humidity adsorption, Ceramic paper, Zeolite paper, Active carbon paper for
adsorption materials, Carbon (chopped)fiber paper and mat for GDL and plane heater and Solvent free gasket manufacturing process for high temperature using.
And working at Korea Institute of Energy Research(KIER).
yjyou@kier.re.krYoonjong Yoo et al., J Material Sci Eng 2017, 6:4(Suppl)
DOI: 10.4172/2169-0022-C1-068