16 / 25
Page 62
conferenceseries
.com
Volume 08
Innovative Energy & Research
ISSN: 2576-1463
Advanced Energy Materials 2019
July 11-12, 2019
July 11-12, 2019 | Zurich, Switzerland
21
st
International Conference on
Advanced Energy Materials and Research
Progress into energy storage technology: About the carborundum foam ceramic structure and the fuel
cells capacity
Karim Ragui
USTHB University of Sciences & Technology, Algeria
T
he present research is about carborundum foam ceramic (SiC) and its huge energy storage capacity in industrial
approaches. Initially observed in 1824 by Jöns J Berzelius in a synthetic diamond experience by a parasite
reaction between carbon and silica, this porous material is found much utilized since the industry of 1890, raison
to its precious properties, such as its powerful resistivity to thermal shocks and chemical oxidation to name but a
few. SiC could be produced at various specific surfaces, as between 10 and 20 m
2
/g. Similarly, the granulometric
composition of the used mixture powder could control its porosity. For industrial applications (as catalysts), the
porosity is ranged between 37% and 45%. Regarding the permeability the key factor for most industrial applications,
a large range of the latter could be denoted. Complement to these properties and following the fuel cells development
in the recent years, such a material could be adopted against the storage instability problem. As observed with
various fluid natures, it was established that the energy storage at low double-diffusive buoyancies consists, usually
of a steady state ratio, easily controlled at pilot processes (and promotive for modest applications). By searching for
a better capacity ratio, following the increase in the buoyancy impact, the fuel cell structure could become unstable,
leading to a huge loss in both the process energy cost and the used materials. Facing to such a big challenge, our
alternative will be themo-mechanical. By taking the annulus shapes as an example, the generation of a high diffusive
gradient between the annulus limits could increase the buoyancy efficiency and the energy ratio consequently. Of
course critical situations will be reached, as the inner sub-flow regimes over the energy storage process. Against such
a part, the full cell shape could light-up the perfect solution. In view of the fact that the nature of industrial processes
is often non-linear, extremely complex and not sufficiently recognized, the development of primary conditions for
energy storage optimization is of practical significance. As such, our presentation at Advanced Energy Materials
Conference, at Zurich, Switzerland, will be undertaken to extend the optimum carborundum foam structure &
buoyancy range to make accurate information about full cells stability and the evolution of the energy storage ratio
during the operation time.
ragui-karim@live.frInnov Ener Res 2019, Volume 08