Spanish 
Chinese 
Russian 
German 
French 
Japanese 
Portuguese 
Hindi Research Article
Laser Cleaning Treatment and its Influence on the Surface Microstructure of CFRP Composite Material
Zhan X1,2*, Gao C1, Lin W1, Gu C1, Sun W2 and Wei Y11College of Material Science and Technology, Nanjing University of Aeronautics and Astronautics, Nanjing 211106, PR China
2Department of Materials Science and Engineering, The Ohio State University, Columbus, OH 43210, USA
- *Corresponding Author:
- Zhan X
College of Material Science and Technology
Nanjing University of Aeronautics and Astronautics
Nanjing 211106, PR China
Tel: 86-10-82865135
E-mail: xiaohongzhan_nuaa@126.com
Received Date: March 17, 2017; Accepted Date: April 21, 2017; Published Date: April 27, 2017
Citation: Zhan X, Gao C, Lin W, Gu C, Sun W, et al. (2017) Laser Cleaning Treatment and its Influence on the Surface Microstructure of CFRP Composite Material. J Powder Metall Min 6: 165. doi:10.4172/2168-9806.1000165
Copyright: © 2017 Zhan X, et al. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
Abstract
Carbon fiber reinforced polymer (CFRP) is one of the most important construction materials in civil aircraft manufacturing. In the current paper, effects of laser surface treatment on the surface microstructure of the CFRP are involved. And the influence of laser surface treatment parameters on shear strength and failure pattern are considered. The optimized parameters including laser scanning speed, laser power, frequency and power density are expected to ensure that the resin and all kinds of pollutants on the surface are cleaned. It is indicated that laser power density significantly influences the surface morphology. The surface with continuous and integrated fibers is helpful for adhesive bonding and is acquirable under appreciate parameters. Maximum shear strength (27 MPa) of adhesively bonded joint was obtained after laser surface treatment.
