Research Article
Growth Rate and Morphology of a Single Calcium Carbonate Crystal on Polysulfone Film Measured with Time Lapse Raman Micro Spectroscopy
Barbara Liszka M1,2*, Aufried Lenferink TM1 and Cees Otto1*
1Department of Medical Cell Biophysics, MIRA Institute, University of Twente, Enschede, The Netherlands
2Wetsus, European Centre of Excellence for Sustainable Water Technology, Leeuwarden, The Netherlands
- *Corresponding Author's:
- Barbara Maria Liszka
Department of Medical Cell Biophysics
MIRA Institute, University of Twente
Enschede, The Netherlands
E-mail: b.liszka@utwente.nl
Cees Otto
Department of Medical Cell Biophysics
MIRA Institute, University of Twente
Enschede, The Netherlands
E-mail: c.otto@utwente.nl
Received date: April 19, 2016; Accepted date: May 17, 2016; Published date: May 23, 2016
Citation: Liszka BM, Lenferink ATM, Otto C (2016) Growth Rate and Morphology of a Single Calcium Carbonate Crystal on Polysulfone Film Measured with Time Lapse Raman Micro Spectroscopy. J Anal Bioanal Tech 7: 321. doi:10.4172/2155- 9872.1000321
Copyright: © 2016 Liszka BM, et al. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
Abstract
The growth of single, self- nucleated calcium carbonate crystals on a polysulfone (PSU) film was investigated with high resolution, time lapse Raman imaging. The Raman images were acquired on the interface of the polymer with the crystal. The growth of crystals could thus be followed in time. PSU is a polymer that is used as a membrane material in water cleaning technology. The intensity of the Raman band at the position of 1086 cm-1, which is due to the symmetric stretching of the C-O bonds in the carbonate group of calcite was used to translate the number of CO3 2- ions in a crystal to the growth in time. The growth rate of single crystals of calcium carbonate on a surface was obtained from successive Raman images. We are presenting for the first time time-lapse Raman images of single crystal growth as a direct method to determine a crystal growth rate on an industrially relevant membrane material, like polysulfone.