Xinyu Mao1,2, Fengxiang X. Han2*, Xiaohou Shao1 and Yi Su3 | |
1College of Water Conservancy and Hydropower Engineering, Hohai University, China | |
2Department of Chemistry and Biochemistry, Jackson State University, USA | |
3Department of Chemistry and Biochemistry, Texas A&M University-Texarkana, USA | |
Corresponding Author : | Han FX Department of Chemistry and Biochemistry Texas A&M University-Texarkana, USA Tel: (601) 979-3487 Fax: (601) 979-3674 E-mail: Fengxiang.han@jsums.edu |
Received January 11, 2015; Accepted January 28, 2015; Published January 30, 2015 | |
Citation: Mao X, Han FX, Shao X, Su Y (2015) Coupled Electro-kinetic Remediation and Phytoremediation of Metal(loid) Contaminated Soils. J Bioremed Biodeg 6:e163. doi:10.4172/2155-6199.1000e163 | |
Copyright: © 2015 Mao X, et al. This is an open-a ccess article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited. | |
Related article at![]() ![]() |
Visit for more related articles at Journal of Bioremediation & Biodegradation
Soil contamination with heavy metals and metalloids has become a serious environmental problem with rapid industrialization and urbanization [1-3]. Generally, the contamination is resulted from anthropogenic activities such as mining, domestic waste discharge, agricultural production and industrial activities. Heavy metals and metalloids such as Cd, Pb, Cr, Cu, Hg, Cs, Se, Zn and As enter the food chain and have adverse effects on human health [1-3]. As the increasing concern on the environmental risk, numerous remediation technologies have been developed while very few methods had been proved to be efficient for cleaning up of heavy metal(loid)s due to their characteristics of persistence and non-degradation in contaminated sites [1,4-10]. |
Phytoremediation is a cost-effective and environmental-friendly remediation thnology for the remeidation of heavy metal(loid)d in soils [4-6]. It promotes water and soil conservation as well as microbial activity improvement. Thus it has proved to be efficient for large area treatment with low pollutant concentration. However, several limitations such as the remediation period, the climatic condition, the root depth, the biomass production and the variety of the contaminants are existed in actual applications [11]. Therefore, selection of plants with high accumulation capacity of contaminants and new technologies for increasing soil heavy metal(loid) bioavailability should be developed. |
Electro-kinetic remediation (EKR) which involves a low intensity electric field has been proposed to enhance phytoremediation. It produces conditions to solubilize metal(loid)s in soils based on the combined mechanisms of electro-osmosis, electromigration and electrophoresis [12]. As a consequence of driving force generated by the passage of current, metal(loid) ions and metal complex migrated from anodes to cathodes could be easily absorbed by plants. Since soil pH polarizations caused by electrolytic decomposition at electrodes, control of soil pH and some key electronic parameters are important for the remediation efficiency [13]. |
This paper reviews the current development on coupled electrokinetic phytoremediation (EK-phytoremediation) technology, including the selection principles of plants for the technology and interactions between heavy metal(loid) input and their bioavailability in soils. Furthermore, assisted amendments and key electronic parameters for the improvement of soil physical-chemical properties and plants remediation effects are also discussed in the paper. |
Coupled EK-phytoremediation Technology |
Generally, coupled EK-phytoremediation techniques contain the application of a low intensity electric field adjoined to growing plants in contaminated soil. Significant variables which can affect the technology include the electric field intensity, use of AC or DC current, mode of voltage application, electrodes configurations and facilitating amendments. Lemstrom first applied electric fields on growing plants and found treated plants were greener and experienced an increase in yield [14] The removal of contaminants by plants in coupled EK-phytoremediation technology are enhanced by increasing the bioavailability of the contaminants through the effect of electric field. Increased soluble heavy metals are drive to the plant roots which might bring stress condition for the plants. Therefore, hyperaccumulators are the best choice for the coupled remediation [15]. It has been proposed sequential use of phytoremediation after EKR is beneficial for the cleanup of residue contaminants and recovery of soil properties damage caused by EKR [16]. However, coupled EK-phytoremediation technology has been proved to be more efficient and effective than the sequential use of these technologies. |
Plant Selection |
Phytostabilization and phytoextraction are often used for the cleaning up of contaminants. Compared to phytoextraction, phytostablization is not a permanent strategy since the contaminants remain in environment. Therefore, phytoextraction becomes the most promising and commercial application for heavy metal(loid) cleaning up in soils. Plants that suitable for phytoextraction possibly should have the features with high growth rate, high resistance to pathogens and pests, highly developed root system, large biomass production of aerial parts, high tolerance to trace metal(loid), great accumulation and translocation ability and good environment adaptability [17]. |
Metals accumulation and biomass are two critical factors for determination of plant species for phytoextraction purpose. Hyperaccumulators often with comparatively low over-ground biomass, accumulate greater amount of target metals. Other plants such as Indian mustard accumulates less metal but produces more over-ground biomass so that the overall accumulation is comparable to that of hyperaccumulators. Hyperaccumulation and hypertolerance are more important than high biomass in phytoremediation. In addition, compared with nonaccumulators, hyperaccumulators with high accumulation of metals in small volume of biomass are easier and more economic to operate for either metals recovery or safe disposal [18]. Plants with multiple harvests in a single growth period have great potentials for phytoextraction. In addition, due to the high growth rate, great adaptability and high biomass, grasses are more favorable than shrubs and trees in phytoremediation [19]. |
Bioavailability of Heavy Metals in Soils |
Bioavailability of trace metal(loid)s in soil is a determining factor which influencing the efficiency of phytoexraction. Only a part of metal in soil is bioavailable for plants uptake. Processes like precipitation or strong binding to soil particles make a large part of soil metals insoluble and unavailable for plants extraction. Metal(loid)s in soil are divided into three categories according to their bioavailability: readily bioavailable (Cd, Ni, Zn, As, Se, Cu); moderately bioavailable (Co, Mn, Fe) and least bioavailable (Pb, Cr, U) [20] Low bioavailability constrains the phytoextraction effects of heavy metals while the changes of soil physical-chemical properties may enhance the bioavailability and mobility of metals. Secretion of H+ ions by roots will be able to demobilize more metals around rhizosphere. Moreover, activities of rhizospheric microbes significantly increase labile metals in soil. Except enhanced in natural phytoextraction, bioavailability of heavy metals in soil can also be increased by adding chelating agents such as EDTA, ammonium sulfate, critic acid and elemental sulfur et al. in induced phytoextraction [9]. |
Key Electronic Parameters for EK-phytoremediation Technology |
Significant electronic parameters are electric field intensity, use of AC/DC current, mode of voltage application and electrodes configurations. Electric field intensity has a determining influence on the effectiveness of EK-phytoremediation. Low voltage was beneficial for Indian mustard growth while the biomass production was decreased as the increase of voltage [21]. However, the increasing bioavailability of heavy metals at elevated voltage and the negative effects of the voltage on the plant development were comprised at an intermediate voltage of 2V with the best metal removal and accumulation on plant tissues [21]. |
Soil pH was reported to decrease from initial pH 6.5 to 3 near the anode and increased to 8 near the cathode with application of DC electric field with potato [22]. Heavy metals had a migration from anode to cathode and an accumulation in the middle of the pot where the pH was 5. On the contrary, no transportation and soil pH change was observed with application of AC electric current. Moreover, potato had 72% increase whereas 27% decline in biomass production under AC and DC electric field, respectively. Overall, test using AC electric field showed higher metals accumulation in both plant roots and shoots than the control test and the DC test [22]. Soil pH changes which resulted from the electrolysis of water were induced by the use of continuous DC electric field. In order to avoid the negative effects, switching the polarity of the DC electric field every 3 h eliminated pH changes and comparable phytoremediation efficiency between the DC and AC tests were achieved [23]. |
The effectiveness of coupled EK-phytoremediation was influenced by electrode configurations. An vertical DC electric field or several electrode arrangements were extended with phytoremediation depth, preventing leaching of Pb [24,25]. The configuration with the cathode in the center surrounded with anodes showed greater potential to metals accumulation [25] Recently a 2D electrode configuration with cathode were placed on the surface of the soil and anodes was vertically installed in four corners of a rectangular chamber. The results showed enhancement in both metal accumulation in roots and shoots and metal translocation towards the shoots [26]. |
Amendments for EK-phytoremediation |
In order to improve metals bioavailability, control soil pH with the favorable range and facilitate plants growth, amendments are added, including chelating or complexing agents, organic amendments and fertilizers etc. Chelants enhance EK-phytoremediation by forming strong water-soluble complex which desorbs metal(loid)s from soil particle surface. EDTA is most frequently used chelant and has been proved to be effective on mobilization of metals like Cr, Fe, Cu, Pb and Zn [9]. The factors included metals species, metal/chelate ratio, presence of competing cations and soil pH et al. In addition, EDTA showed some phytotoxicicty to plants [9]. Complexing agents such as I−, Cl−, NH4 + may form soluble complexes with metal ions. Ammonium thiosulphate could result in the solubilization of Hg enhancing accumulation in plant roots and shoots [27]. Furthermore, acetic acid and lactic acid is used to neutralize the electrolysis product at the cathode and keep the electrolyte pH within a certain range. Ammonium acetate was beneficial for increasing Cu solubility and removal rate [28] Organic amendments such as sewage sludge and green waste composts improve plant growth by enhancing the physicochemical and biological conditions of soils. They also directly or indirectly alter the distribution and availability of soil metals. Several reports revealed that amended compost increased As mobility due to the competing effect of DOC and soluble P component with As for sorption sites. Moreno-Jimenez et al. discovered the mobilization of As, Cu and Se in flooded soils after the application of olive mill waste compost. In contrast, reports also indicated that the bioavailability of Pb was decreased when added compost [27]. Clemente et al. [29] found an increase in mobility of As and Sb after the two years application of compost mulch in soil which enhanced the uptake by lettuce and sunflower [29]. |
Conclusion |
The coupled EK-phytoremediation technology is promising for the clean-up of heavy metal(loid)s in contaminated soils. More research is necessary for its practical design and application before applying at field scale. The research directions are suggested in following aspects such as: determine the distribution, translocation and environmental risks of heavy metal(loid)s and their influence on plants metal(loid) s accumulation; test and select the hyper accumulators which possess remarkable metal(loid)s accumulation ability for this coupled technology; test the remediation efficiency of the coupled technology in sites with both organic and inorganic contaminants; try to apply assisted amendments of natural or biodegradable products; elucidate the mechanisms and influence of electronic parameters on metabolism and growth of plant as well as uptake and translocation of metal(loid)s. |
Acknowledgement |
This research was supported by U.S. Nuclear Regulatory Commission (NRC–HQ-12-G-38-0038), NOAA-ECSC grant (NA11SEC4810001), NIH-RCMI grant (G12MD007581), the Jiangsu Scientific Research Innovation Program of Ordinary Higher Education Graduate (China) (KYZZ0156), the Fundamental Research Funds for the Central Universities (China) (2014B00114). |
References
|
Make the best use of Scientific Research and information from our 700 + peer reviewed, Open Access Journals